Superdome Servers - I/O Expansion Cabinet Guide, Fifth Edition

Chapter 5

Adding an ICE to the IOX

Preliminary Installation

The following is a list of tools required for ICE assembly and service operations:

• Anti-static mat with provisions for connecting to chassis ground

• Wrist strap

• T-8, T-10, T-15, T-20, T-25 Torx bits

•Drive extension

• #1 and #2 Phillips bits

• Allen wrench set

• Nut drivers set

• 6-inch crescent wrench

The IOX cabinet is shipped with at least one ICE. Additional ICEs, however, may be installed later.

The ICE may be mounted in one of three locations in the rack.

To install an ICE into the IOX cabinet:

Step 1. Remove the ICE from its shipping carton and inspect it for damage.

Step 2. Determine where the ICE is to be located.