Superdome Servers - I/O Expansion Cabinet Guide, Fifth Edition

Chapter 5
Adding an ICE to the IOX
Connecting the Cables
106
NOTE Each REO cable has two connectors (input and output) that attach to each XMIOB.
There are two XMIOBs per ICE, one for each I/O chassis, but you may only have one
I/O chassis, and therefore, will only connect one pair of connectors to one XMIOB.
Step 2. Pass the cables over the cable management arm, under the cable strain relief arm, and run the
connectors through the appropriate REO ferrule mounting hole(s). Mark the opposite end of this
REO cable with the correct XMIOB number. This will help in the identification for later attachment
to the Superdome.
Figure 5-12Securing REO Cables
Step 3. Remove the strain relief bracket.