Superdome Servers - I/O Expansion Cabinet Guide, Fifth Edition

Chapter 6
Remove and Replace Procedures
Removing the ICE
134
Step 5. Disengage the lock pins and slide out the ICE on its tray. Pull them out and give one-quarter turn.
Figure 6-6Extending the ICE
Removing the Cables
The following cables must be removed from the ICE chassis.
• REO
•Clock
•Fan control
• Utilities
•DC power
• I/O cables connected to the I/O chassis
NOTE Be sure to identify each cable as you remove it. To make sure you put it back on the correct
connector later, mark each cable with tape or by some other means so that it may readily
identified later.
IMPORTANT Mark all cables.
Step 1. Disconnect all I/O cables from the I/O chassis at the front of the ICE.
Step 2. Pull the I/O cables from the ICE under the I/O chassis and pull them out the back of the IOX.