Superdome Servers - I/O Expansion Cabinet Guide, Fifth Edition

Chapter 6
Remove and Replace Procedures
Removing and Replacing the ICE XMIOB
154
Step 4. Re-install the fan shield previously removed by tightening the four T20 Torx screws.
Step 5. Re-install the two fan modules and tighten the four T10 Torx screws on each of them.
Step 6. Re-install the I/O chassis by following the procedure outlined in “Replacing the I/O Chassis” on
page 147 and re-install the chassis.
Step 7. Push in the slide rail locks and slide the ICE into the cabinet and tighten the tray locks.
Step 8. Re-attach the front EMI panel.
Step 9. Install the front cosmetic bezel.
Step 10. Connect the DC power cable to the ICE.