Superdome Servers - I/O Expansion Cabinet Guide, Fifth Edition

Chapter 6
Remove and Replace Procedures
Removing and Replacing the XPC
166
Removing and Replacing the XPC
Required Tools
The following is a list of tools required for IOX assembly and service operations:
• Anti-static mat with provisions for connecting to chassis ground
• Wrist strap
•T-20 Torx bit
• Torx drive extension
• Torx in-lb torque driver
Removing a XPC
To remove the XPC, perform the following procedure:
Step 1. Open the rear door
Step 2. Remove the front XPC cosmetic bezel.
Step 3. Remove the AC power cord(s) from the back of the XPC.
Step 4. Remove all cables from the rear of the XPC.
IMPORTANT Be sure to identify each cable as you remove it. To make sure you put it back on the
correct connector later, mark each cable with tape or by some other means so that it
may readily identified later.
Step 5. Remove the ground cable from the rear lug.
Step 6. Loosen the BPS safety latch located at the front and top of the XPC.
Step 7. Remove the two BPSs from the XPC by pulling the handle on each.