Superdome Servers - I/O Expansion Cabinet Guide, Fifth Edition

Chapter 1
Introduction
Cabinet Description
20
The cabinet columns are a folded design made of 12-gauge rolled steel that supports up to 2000 lbs. Running
up the inside of the fold are square mounting slots for the rails and screw holes for securing the rails. The hole
placement conforms to EIA standards. The mounting columns are welded into place at the bottom corners of
the frame and bolted at the top. The columns accept supporting rails into mounting slots. Each support rail
pair attaches between the front and rear columns. The equipment is then mounted on the support rails.
The mounting columns have pre-positioned threaded inserts pressed into the hexagonal accessories holes in
the front faces of the columns. The inserts are positioned to accept tie brackets, hinges, latches, and Plus.
Anti-Tip Stabilizer Feet
IOX cabinet has a field installable set of stabilization feet as standard equipment. These stabilization feet are
installed at the front and rear of the cabinet.
WARNING Install the Anti-Tip stabilizer feet for safety.
Figure 1-18 Anti-Tip Stabilizer Feet
5/14/01
60IOX002
Rear Stabilitzer Foo
t
Front Stabilizer Foot