Superdome Servers - I/O Expansion Cabinet Guide, Fifth Edition

Chapter 2

Upgrading the Superdome for IOX

Finishing the Upgrade

Once the new exit panels are installed, the rear door (if removed), and blower bezel(s) must be reinstalled

onto the Superdome cabinet(s). Perform the preceding procedures in reverse.

Reinstalling the Rear Door

NOTE Perform the following steps only if you had to remove the rear door to the Superdome cabinet.

Step 1. Attach the door-hinge assembly using the six T20 Torx screws.

Step 2. Carefully lift the rear door and slide it over and onto the three hinge pins.

Figure 2-12Reinstalling the Rear Door

Step 3. Reattach the rear display panel connector.

Step 4. Reattach the ground wire.

Reinstalling the Blower Bezels

Attach the blower bezels removed earlier.