Hewlett-Packard SureStore 125ex Optical Jukebox User's Guide - C1118-90000

SETTING UP THE JUKEBOX

JUMP

CONTENTS

INDEX

The numbers below correspond to the numbers in Figure 1-1 on the previous page.

Table 1-1:

1 Power receptacle Used to connect the power cord to the jukebox.

2 Standby/on switch The ON position applies power to the robotics and

electronics in the jukebox. The STANDBY

position removes power from the robotics and

electronics of the jukebox but power remains ON

inside the power supply enclosure on the rear of the

jukebox.

To remove power completely from the jukebox,

you must remove the power cable either from the

rear input on the jukebox or at the wall/floor

electrical outlet.

3 SCSI ports Two 68-pin high-density connectors that allow

connection to either a single-ended or low-voltage

differential SCSI bus. A terminator must be

plugged into one of these connectors when the

jukebox is the last physical device on a SCSI bus.

The terminator shipped with the jukebox is a

single-ended / low-voltage differential terminator.

For the most flexible configuration, use a self-

configuring single-ended / low-voltage differential

terminator (SE/LVD) even though the jukebox may

be originally configured onto a low-voltage

differential bus.