Hewlett-Packard SureStore 125ex Optical Jukebox User's Guide - C1118-90000

OPERATING THE JUKEBOX

JUMP

CONTENTS

INDEX

The security code 0 0 0 is set at the factory. This code is used when accessing and setting jukebox configurations.

Consider changing the security code so that only authorized persons can change the configurations.

NOTE:

Don’t forget your security code. If you forget it, only your service representative can reset the security code to the factory

setting so you can set a new code.

Start with READY or SECURE in the display.

1. Press NEXT until CONF * displays

2. Press

ENTER. CONF 0 and a flashing 0 displays.

3. Press

NEXT until CONF 17 displays.

NOTE:

Starting from when you press ENTER in the next step, you are prompted to enter the current security code.

4. Press ENTER. CODE 1 and a flashing 0 displays.

5. Press

NEXT until the first number of your current security code displays.

6. Press

ENTER. CODE 2 and a flashing 0 displays.

7. Press NEXT until the second number of your current security code displays.

8. Press

ENTER. CODE 3 and a flashing 0 displays.

9. Press

NEXT until the third number of your current security code displays.

10. Press ENTER.

NOTE:

If you entered an incorrect code, NO CONFIG displays briefly and then CONF 17 displays. Repeat steps 4-10 again and

enter the correct current code.