Hewlett-Packard SureStore 125ex Optical Jukebox User's Guide - C1118-90000

OPERATING THE JUKEBOX

JUMP

CONTENTS

INDEX

NOTE: CONFLICT displays if you attempt to set the jukebox controller and a drive to the same ID. Repeat the procedure and

reset one of the IDs to another, non-conflicting ID.

NOTE: After you change an ID you may have to restart your host computer for the new ID to be recognized.

Caution:

Do not turn power to STANDBY in this jukebox until you are sure the SCSI bus is inactive. Removing power from a SCSI

peripheral when the bus is active can result in data loss and/or indeterminate bus states. Check your host system manuals for

information about checking the SCSI bus status.

7. Switch the jukebox standby/on switch to STANDBY, the back to ON to save the new SCSI ID in jukebox memory.

CHANGING AN OPTICAL DRIVE ID

Start with READY or SECURE in the display.

1. Press

NEXT until SCSI ID * displays.

2. Press ENTER. AC ID * displays. (“AC” is the “jukebox controller.”)

3. Press

NEXT until DRV 1 ID * or DRV 2 ID * (if your jukebox has two drives) displays.

4. Press

ENTER. DRV # ID? displays, where “#” is the number of the drive you selected in step 3 and “?” is the ID to

which your selected drive is currently set.

5. Press

NEXT until the ID you want displays.

6. Press

ENTER. SET # (# is a number from 0-7) displays briefly and then DRV # ID # displays again. The ID you

chose is now set.

7. Press

CANCEL two times to return to the READY state.