Optical Drive and Library SCSI-2 Command Reference

SCSI Command Overview
Drive Control Commands
Chapter 11-10
Message Reject 07H
This message is sent from either the initiator or the target to indicate
that the last message was inappropriate or has not been implemented.
When the target receives a MESSAGE REJECT message from the
initiator, it takes the following action based on which message was
rejected.
Command
Complete The target goes to Bus Free Phase and does not consider
this as an error.
Disconnect The target does not disconnect and continues the cur-
rent command.
Identify The target goes to the Bus Free Phase and aborts the
command. Sense Key/Additional Sense Code is set to
Hardware Error/Message Reject Error.
Linked Command
Complete The target goes to the BUS FREE phase and aborts the
command and sets Sense Key/Additional Sense Code to
Aborted Command/Message Error.
Message
Reject The target terminates the command with Check Condi-
tion status and sets the Sense Key/Additional Sense
Code to Hardware Error/Message Reject Error.
Restore
Pointers The target goes to the Bus Free Phase and sets the
Sense Key/Additional Sense Code according to the error
condition.
Save Data
Pointers The target does not disconnect and continues the cur-
rent command.