Optical Drive and Library SCSI-2 Command Reference

Autochanger Error Codes
Jukebox Micro-Move Error Codes
Appendix B B-51
Autochanger Error Codes
60 FRU Isolation Test Assumes that something has physically failed,
either electronic or mechanical. A series of
special low-level tests are executed to select the
three (or fewer) FRUs which are most likely to
be at fault. Tests 30, 31, 33, 35, 36, 40, and 50
are executed as a part of the isolation process.
65
Calibrate Magazines Calculates a min/max clearance for a magazine.
(The selected magazine should be empty.) The
autochanger requires a disk in the mailslot. The
test passes if clearance is 85 encoder counts (1
mm) up and down. (See Info 23 for actual
values.)
If this test is run by SCSI command, set Byte 1
to the magazine number.
The test returns: PASS or FAIL.
66
Clear Magazine Min/
Max
Clears the value calculated in Test 65.
67
Calibrate Mailslot Calculates a min/max clearance for the mailslot.
The autochanger requires a disk in the mailslot.
The test passes if clearance is 85 encoder counts
(1 mm) up and down. (See Info 23 for actual
values.)
The test returns: PASS or FAIL.
68
Clear Mailslot Max/
Min
Clears the value calculated in Test 67.
75
UPS Test Tests whether or not the UPS is connected
properly.
The test returns PASS if connected properly,
FAIL if the UPS is not connected properly or if
there is no UPS connected.
Table B-13 Sequence Tests (For models 40fx, 80ex, 125ex, and 220mx ONLY)
No. Test Name Description