Optical Drive and Library SCSI-2 Command Reference

SCSI-2 Drive Command Set
Mode Select Command (15H)
Chapter 2 2-35
SCSI-2 Drive Commands
PER A Post Error bit of 1 indicates that the target reports
recovered errors.
A PER bit of 0 indicates that the target does not report
recovered errors.
DTE A Disable Transfer on Error bit of 1 indicates that the
target terminates the data phase upon detection of a
recovered error.
A DTE bit of 0 indicates that the target does not
terminate the data phase upon detection of a recovered
error.
DCR A Disable Correction bit of 1 indicates that error
correction codes are not used for data error recovery.
A DCR bit of 0 allows the use of error correction codes
for data error recovery.
Read Retry
Count The Read Retry Count field specifies the number of
times the target attempts recovery of a read operation
before reporting an error.
Write Retry
Count The Write Retry Count field specifies the number of
times the target attempts recovery of a write operation
before reporting an error.