HP SureStore Optical Disk Drive User's Guide - C1114-90015

Chapter 1 1-5
Setting up the Disk Drive
Rear Panel Features
Chapter 1: Setting
up the Disk Drive
Setting up the
Disk Drive
The following numbers correspond to the numbers in the drawing on the previous
page.
1SCSI ID switch Used to set the SCSI ID. Refer to “Setting
the SCSI ID” in this section.
2 Operation mode switch Used to choose the operating mode and set
your preference for write verify. Refer to
“Setting the Operation Mode” in this
section.
3 Power connector Receptacle for the power cord.
4 On/Off switch Used to switch power on or off.
5 SCSI connector (with
terminator attached)
50-pin high-density SCSI connector
(Micro D-type). Terminator may be
attached to either connector (see “6”).
A terminator must be plugged into either
“5” or “6” when the drive is the last
physical device on a SCSI bus.
6 SCSI connector (with
cable attached)
50-pin high-density SCSI connector
(Micro D-type). Cable may be attached to
either connector (see “5”).
A terminator must be plugged into either
“5” or “6” when the drive is the last
physical device on a SCSI bus.