HP SureStore Optical Disk Jukeboxes User's Guide - C1104-90015

3-14 Chapter 3
Operating the Jukebox
Changing the Administration Menu Password
Changing the Administration Menu Password
READY > ADMIN * > PSWD 000 000 000 >CONFIG *
1. Follow the steps on the previous page to enter your password (or the default,
factory-set password 000 000 000).
2. TEST * displays. Press
NEXT until CONFIG * displays, and then press ENTER.
3. Press
NEXT or PREV or until NEW PASSWORD displays and then press ENTER.
4. NEW 000 000 000 displays and the first set of three zeros flashes. Press
NEXT or PREV until the new number you wish to assign to the first part of the
password displays and then press
ENTER. The second set of three zeros flashes.
5. Press
NEXT or PREV until the new number you wish to assign to the second part
of the password displays and then press
ENTER. The third set of three zeros
flashes.
6. Press
NEXT or PREV until the new number you wish to assign to the third part of
the password displays and then press
ENTER.
7. PASSWORD CHANGED displays. Press
CANCEL three times to return to READY
CAUTION Turning off the jukebox in the next step could cause data loss if not done correctly.
Do not turn off power to the jukebox until you are sure the SCSI bus is inactive.
Removing power from a SCSI device when the bus is active can result in data loss
and/or indeterminate bus states. Check your host system manuals for information
about checking the SCSI bus status. If your computer is connected to a LAN, be sure
to check with your system administrator before turning off power to the jukebox.
8. Turn the jukebox OFF, then ON to save the password to the jukebox flash
ROM.