HP SureStore Optical Disk Jukeboxes User's Guide - C1104-90015

Chapter 3 3-15
Operating the Jukebox
Setting the SCSI IDs
Operating the
Jukebox
Setting the SCSI IDs
NOTE If you are unfamiliar with basic SCSI addressing or LUN addressing, refer to
Appendix B. A web site is also available for more extensive information at:
www.hp.com/isgsupport/optical/index.html
First, determine if you are using basic SCSI addressing or logical unit numbering
(LUN). Setting the LUN mode is explained below.
Next, either view the current SCSI IDs or proceed directly to setting IDs. The next
two procedures are “Viewing the Current SCSI IDs” and “Changing the Current
SCSI IDs.”
Tables showing default SCSI IDs for basic SCSI addressing and LUN addressing
are in Appendix B.
Setting the LUN Mode
READY > ADMIN * > SCSI ID’S * > CHOOSE LUN MODE *
NOTE If you are unfamiliar with basic SCSI addressing or LUN addressing, refer to
Appendix B. A web site is also available for more extensive information at
www.hp.com/isgsupport/optical/index.html.
NOTE Check your host system documentation and jukebox application software
documentation to verify that the use of LUNs is supported.
Start with READY in the display.
1. Press
NEXT until ADMIN * displays and then press ENTER.
2. Enter the administration password.
Instructions for entering this password are in “Entering the Administration
Menu Password” previously in this chapter.
3. Press
NEXT until SCSI ID’S displays, and then press ENTER.
4. VIEW ID’S displays. Press
NEXT until CHOOSE LUN MODE * displays and
then press
ENTER. LUN MODE ON or LUN MODE OFF displays and ON or OFF
is blinking.