HP SureStore Optical Disk Jukeboxes User's Guide - C1104-90015

3-20 Chapter 3
Operating the Jukebox
Setting an Operating Configuration
Setting an Operating Configuration
READY > ADMIN * > CONFIG *
You can set configurations to customize the way the jukebox operates.
Start with READY in the display.
1. Press
NEXT until ADMIN * displays.
2. Enter the administration password.
Instructions for entering this password are in “Entering the Administration
Menu Password” previously in this chapter.
3. TEST * displays. Press
NEXT until CONFIG * displays, and then press ENTER.
4. Press
NEXT or PREV until the name of the configuration you wish to set displays
and then press
ENTER. (Configurations are described on the following pages.)
If the configuration has multiple settings, the current setting flashes. Otherwise,
the configuration is set and a confirmation message displays.
5. If the current configuration setting is flashing, press
NEXT or PREV until the
desired setting displays, and then press
ENTER. OPTION SAVED displays and
then the configuration’s name and setting displays.
6. Press
CANCEL to return to READY.
CAUTION Turning off the jukebox in the next step could cause data loss if not done correctly.
Do not turn off power to the jukebox until you are sure the SCSI bus is inactive.
Removing power from a SCSI device when the bus is active can result in data loss
and/or indeterminate bus states. Check your host system manuals for information
about checking the SCSI bus status. If your computer is connected to a LAN, be sure
to check with your system administrator before turning off power to the jukebox.
7. Turn the jukebox OFF, then ON to save the configuration to the jukebox flash
ROM.
Configurations are described in the following table.