HP CD-ROM Server User's Guide

2-4 Basic Installation
Transceivers
For the Tower Module only.
HP provides the following AUI
transceivers:
Towers and
SCSI Drives
HP provides the following towers and SCSI drives:
Connecting the Hardware
Before You Begin • Stand-alone version only: Make sure that the power supply
(19 Vdc) included with your product is marked with the
correct AC voltage and frequency for your country.
• Verify that power is not connected to the CD-ROM server
or any of the CD-ROM drives when making changes to the
SCSI cables. The SCSI bus may be damaged if you connect or
disconnect any units when the power is on.
• If you have not already done so, record the LAN hardware
(MAC) address of the CD-ROM server. You will need this
address during installation. The address is printed on the label
placed on the bottom of the server, in the form
00-60-B0-hh-hh-hh (where h is a hexadecimal number).
• Verify with your Network Administrator that a network
connection is set up to connect the CD-ROM server and
configure it onto the network.
HP Product AUI Transceiver
28641B ThinLAN coaxial cable (BNC)
28683A Fiber-optic cable (ST)
HP Product Description
C2987A
8-bay tower for HP CD-ROM Server Tower
Module. Provides SCSI backplane plug-in
connectors.
C2988A
7-bay tower for HP CD-ROM Server Stand-
Alone Module (requires a SCSI cable to the
first drive). Provides SCSI backplane plug-in
connectors.
C2997A
HP 20X CD-ROM drive (includes SCSI plug-in
assembly)
hp.book Page 4 Thursday, April 2, 1998 4:33 PM