HP CD-ROM Server User's Guide

2-10 Basic Installation

6. Turn power on using the following instructions:

• Stand-alone version only: First connect power to all

CD-ROM drives and turn them on. Then connect the

external power supply to the HP CD-ROM Server.

• Tower module only: Simply switch the power on to the

entire CD-ROM tower assembly containing the drives

and HP CD-ROM Server.

7. Observe the CD-ROM server’s indicator lights. They will all

flash during power-on and self-test. When the STATUS

indicator (yellow) stops flashing and remains off, the CD-ROM

server is ready for use.

Depending on the number of drives in use, this may take from

a few seconds to several minutes.

8. Insert a CD-ROM disc into a drive and verify that the ‘CD’

indicator (green) on the CD-ROM server turns on. If it does not,

verify your SCSI cable connections and addresses, then power

cycle the CD-ROM server. (If it still does not turn on, refer to

appendix A.)

Hardware installation is now completed. Proceed to chapters 3,

4, 5 and 6 to setup your CD-ROM server for use.

hp.book Page 10 Thursday, April 2, 1998 4:33 PM