HP SureStore AutoBackup Administrator's Guide - Not Orderable

8001
Drive
Fault
E
The drive has detected an internal
error.
8004
Eject Fail
E F
An eject command has failed,
either after you pressed the Eject
button or after a host command.
Action: Try forcing ejection.
2010
Eject Mag
I The Eject button has been pressed.
1015
Erase
S
The drive is erasing data from the
tape.
8000
Error X
E F
The mechanism has jammed. The
number X identifies the reason for
the jam.
Action: Press the Eject button to
attempt to recover the cartridge and
magazine. If the problem persists,
note the value of X and call for
service.
1023
ForceEject
I
A forced ejection is in progress
(see Forcing Ejection).
1014
Format
S
A SCSI command for generating a
one- or two-partition tape is being
executed, or the drive is changing
the size of the partitions on an
existing two-partition tape.
FRU 1 Dead
E O
The controller board for the drive
mechanism in the autoloader has
failed its self-test.
Action: Call for service.
FRU 2 Dead
E O
The drive mechanism has failed its
self-test
Action: Call for service.
3002
FW Check
S
Firmware upgrade data is being
checked for compatibility.
8024
FW Data
Err
E F
The autoloader has failed to
upgrade the firmware because the
new firmware is corrupt.
Action: Obtain a good copy of the
firmware upgrade.
3004
FW New
FW!!!!
S
The firmware upgrade process has
been successfully completed.
Front Panel Lights, Autoloader
file:///D|/ADMIN_~1/eng/tape/lights_a.htm (10 of 17) [5/3/2000 3:33:43 PM]