HP SureStore AutoBackup Administrator's Guide - Not Orderable

Insert the magazine through the door in the front of the autoloader. Make sure
that the large arrow is uppermost and pointing towards the autoloader, as shown
below.
1.
Apply steady pressure until the mechanism takes the magazine and pulls it into
the autoloader. The autoloader will then check which magazine slots contain
cartridges.
3.
When the magazine check is complete, use either your backup software on the
host computer or the autoloader's front panel buttons to select and load a
cartridge from the magazine into the drive.
4.
The drive now performs a load sequence. This takes a maximum of 25 seconds from
the time the cartridge is inserted to the time the drive is ready to start acting upon the
next command from the host. The sequence is as follows:
Loading And Unloading, Autoloader
file:///D|/ADMIN_~1/eng/tape/load_a.htm (2 of 4) [5/3/2000 3:33:47 PM]