HP SureStore AutoBackup Administrator's Guide - Not Orderable

Power cycle the drive.
Discard the old tape and restart the operation with a different tape.
Use new recommended media.
Correct environmental conditions and/or ensure tapes are allowed to adjust to
new environment before using.
If this was not successful then call for service
Tape jammed in drive
First check :
Check whether there is actually a tape in the drive
Check power connected. Check fuse. Check power cord.
Will the tape eject with a force eject? (hold down the eject button >10
seconds)
Then do this :
Ensure power to the drive (check plugged in and switched on, change power
cable).
Power cycle the drive.
If another drive is available to swap in, try this to confirm drive or power
problem.
Push the unload button and if the tape doesn't eject hold the unload button for
approximately 10 seconds to force eject. If this fails turn the power off and on
again.
Power cycle the drive
If the tape is eventually ejected, discard the old tape and restart the operation
with a different tape.
Only use new, recommended media.
Correct environmental conditions and/or ensure tapes are allowed to adjust to
new environment before using.
If this was not successful then call for service
Stuck tape
First check :
Check whether there really is a tape in the drive (Is door partly or fully
open?)
Check power connected. Check fuse. Check power cord.
Will the tape eject with a force eject? (Hold eject button down >10 seconds)
Troubleshooting, Tape Drive
file:///D|/ADMIN_~1/eng/trouble/trouble4.htm (13 of 19) [5/3/2000 3:34:29 PM]