HP SureStore AutoBackup Administrator's Guide - Not Orderable

System software
Auto-repaired
Web:
YES Critical
LCD: YES
Status Light:
Flashing
YELLOW
Your HP SureStore AutoBackup
system software was automatically
repaired after an operating system
failure, without any loss of backup
data. No further action is required.
User-initiated via detailed
message page
System software
Rebuild/update
successful
Web:
YES Info
LCD: NO
Status Light:
GREEN
Your HP SureStore AutoBackup
system software was successfully
repaired/updated without any loss
of backup data (after a manual
software reset or CD-ROM
software update). No further action
is required.
User-initiated via detailed
message page
Disk repair successful Web:
YES Info
LCD: NO
Status Light:
GREEN
Your HP SureStore AutoBackup
system software was automatically
repaired after a data disk
replacement, but backup data could
not be recovered and was deleted.
You can recover the backup data
by performing an appliance
recovery from tape if you have a
tape backup of your HP SureStore
AutoBackup system
User-initiated via detailed
message page
System software rebuilt Web:
YES Info
LCD: NO
Status Light:
GREEN
Your HP SureStore AutoBackup
system software was successfully
repaired/updated, after a manual
software reset with data deletion or
CD-ROM software update to a
new software major version. Any
backup data that was stored on the
system has been deleted.
User-initiated via detailed
message page
Settings lost Re-install
system
Web:
YES Critical
LCD: YES
Status Light:
Flashing
YELLOW
While performing a repair or
update of the system software, an
error occurred while attempting to
restore the original software
configuration settings. The system
has now returned to a factory
default state, so you will need to
re-run the HP SureStore
AutoBackup Setup CD-ROM.
User runs AutoBackup
Setup CD to configure
networking
Troubleshooting, Alert Messages
file:///D|/ADMIN_~1/eng/trouble/alerts.htm (10 of 23) [5/3/2000 3:34:44 PM]