1 HV Installation and Operations Guide

124 Backup/Restore Configuration Settings Chapter 5

Configuration restore procedure:

1. Connect the bridge to the Ethernet network used by your computer.

2. Start your FTP program using the bridge's IP address:

ftp <IP address>

The default IP address is 1.1.1.1. Refer to the information on changing the

bridge IP address in Ethernet Connection on page 64.

3. Use

[root] as the user name and [password] as the password.

Refer to the information on changing the user name and password in

Ethernet Connection on page 64.

4. Specify binary mode:

Bin

5. Specify the configuration's path and filename (.cfg file) with the

[put] command: put <path:filename.cfg>

The file will transfer and the bridge will reboot. The bridge will then be using

the configuration.

Note You should confirm the new configuration by checking that the

settings are correct.