HP Surestore Bridge FC 2/1 LV and FC 4/1 HV Installation and Operations Guide
Chapter 6 Main Menu 139
Chapter 6
Select an AL_PA value from the table and enter it into the field Enter loop
address of AL_PA at the bottom of the screen.
For more information, see Appendix C.
Main Menu > Configuration > FC to SCSI Mapping
This menu allows for setting the Fibre Channel Address method, Hard Address
value, discovery mode, WWN overrides and FC Port mode.
Figure 44 FC to SCSI Mapping Page
■ Mode Selection determines the mode of Fibre Channel to SCSI Mapping.
The following options are available:
SCC
Indexed
Auto-assigned, LUN priority
Auto-assigned, target ID priority
Auto-assigned, bus number priority
SCC mode is used to address SCSI devices attached to the bridge using
the SCSI-3 Controller Commands method of logical unit addressing. In this
mode, the bridge will respond to FCP commands as in a SCC controller
device. The FC HBA must support this addressing method.