HP Surestore Bridge FC 2/1 LV and FC 4/1 HV Installation and Operations Guide
200 Appendix B
Note Indexed Mode — Controller LUNs are numbered beginning with
LUN 0x50 (80d). There may be a gap between the last device
and the first controller LUN.
Note Host software must use the Inquiry command in order to
determine which bridge LUNs are controller LUNs verses device
LUNs. See the Inquiry and Report LUNs commands in the
In-Band Management section of this appendix.
The following is a list of the commands that are supported by the controller
LUNs. All of these commands are SCSI-3 commands. Complete definitions of
SCSI-3 commands can be found in the SCSI-3 standard available from the
American National Standards Institute (ANSI).
The following is a list of the commands that are supported by the controller
LUNs. All of these commands are SCSI-3 commands. Complete definitions of
SCSI-3 commands can be found in the SCSI-3 standard available from the
American National Standards Institute (ANSI).
General Commands:
■ REPORT LUNS
Copy Manager
■ RECEIVE COPY RESULTS
■ EXTENDED COPY
In-Band Management
■ LUN INQUIRY
■ MODE SELECT (6 & 10)
■ MODE SENSE (6 & 10)
■ RELEASE (6 & 10)
■ RESERVE (6 & 10)
■ TEST UNIT READY
■ WRITE BUFFER