1 HV Installation and Operations Guide

Chapter 1 Fibre Bridge Components and Supported Products 25

Chapter 1

Fibre Bridge Components and Supported Products

This section includes a list of all parts supplied with the bridge, products that

Hewlett-Packard supports for use with the bridge, environmental

considerations, and sample system configurations.

Table 2 lists the supplied parts for the FC 2/1 LV. Table 3 on page 26 lists the

supplied parts for the FC 4/1 HV.

Table 2

Supplied Components for the FC 2/1 LV

Item Qty Description

HP Surestore Bridge FC 2/1 HV 1 Fibre bridge

SW optical GBICs 2 Gigabit Interface Converter: 1 GBIC is pre-

installed in the bridge, 1 is included in the

accessory pack.

Optical cable 1 16 meter FC optical cable, 50 um

Rackmount L-brackets 2 Right and left L-brackets are used for

installing the bridge into a rack.

Rackmount Hardware Kit 1 pkg

■ Four 6-32 0.375 inch screw pan head

pozidrive with lock washers (for

mounting L-brackets to the bridge).

■ Four 10-32 0.625 inch screw pan head

pozidrive (for mounting L-brackets to the

HP rack).

■ Four 10-32 inch clipnuts (for mounting

L-brackets to the HP rack).

■ Four M6-1 16mm screws (for mounting

L-brackets to a Compaq rack).

■ Four M6-1 w/10mm cage nuts (for

mounting L-brackets to a Compaq

rack).

Stick-on rubber feet 4 Rubber pads for the bottom of the Fibre

bridge. (Not required for rackmount

installation.)