1 HV Installation and Operations Guide

Chapter 3 Installing Cables 73

Chapter 3

Power Cord Connection

The power cord shipped with the bridge is a 120 VAC three-conductor power

cord for use specifically with the power distribution unit (PDU) shipped with the

bridge. If you are planning to use another input voltage or if you plan to use

the bridge in applications other than the supported libraries, you must supply

your own power cord.

To connect the power cord to the bridge:

1. Make sure the bridge’s power switch is in the off position.

2. Connect the power cord to the power connector located at the back of the

bridge and the other end into the power source (see Figure 34).

3. Before switching on power to the bridge, refer to Serial Port Connection

on page 64 and Autobaud Feature on page 65 for instructions on

establishing serial communications with the bridge. For an explanation of

the various methods available for configurations, see Chapter 4.

Figure 34 Bridge Power Switch and Connector