HP Surestore Bridge FC 2/1 LV and FC 4/1 HV Installation and Operations Guide
Chapter Overview 75
Configurations
Chapter Overview
■ Powering on the System on page 76
■ Changing the Default Settings on page 77
■ Setting Up Serial Port Communications on page 80
■ Power-Up Messages for the FC 2/1 LV on page 81
■ Power-Up Messages for the FC 4/1 HV on page 83
■ Perform Configuration on page 85
Because the various configuration methods of the bridge offer such similar
functionality, this chapter will describe specific configuration options from the
perspective of the serial interface only.
The bridge allows the user to access many configuration settings through the
serial interface. Among these settings are:
■ Baud rate of the serial port
■ Fibre Channel address
■ SCSI initiator IDs
■ Ethernet IP and MAC addresses
■ Fibre Channel-to-SCSI mapping
■ Trace level settings
All of the above settings may be changed and saved.
Note Unless otherwise indicated, configuration changes take effect
when the bridge powers-on or reboots.
4