1 HV Installation and Operations Guide

84 Power-Up Messages for the FC 4/1 HV Chapter 4

Note If you do not see messages on your screen, re-check your

computer’s serial port settings and press

[Enter] 5 or 6 times. In

particular, make sure the baud rate is set to one of the values

listed in Table 15 on page 80.

The main menu appears as follows:

The main menu allows for various operations to be performed on the bridge.

Option 1) is described below. For information on options 2) through 5), see

Chapter 5.

HP Surestore Bridge FC 4/1 HV

Version X.X XXXX

1) Perform Configuration

2) System Utilities

3) Display Trace and Assertion History

4) Reboot

5) Download a New Revision of The Firmware

Command >