1 HV Installation and Operations Guide

90 Perform Configuration Chapter 4

■ Select 1) to change the initiator SCSI ID. This is the ID for the SCSI

device that requests operations from other SCSI devices known as targets.

This should be a unique ID on the bus, the default is 7.

■ Select 2) to add a target SCSI ID. This section is used only when the

bridge is configured as a SCSI target for use with SCSI initiators. This is

NOT relevant to the use of the bridge in a tape library or MO jukebox.

This adds an ID for a SCSI device that responds to operation requests from

the SCSI initiator. This must be setup before users can access SCSI to Fibre

Channel mapping (from the SCSI to Fibre Channel Mapping

Configuration menu).

■ Select 3) to remove a target SCSI ID. This section is used only when

the bridge is configured as a SCSI target for use with SCSI initiators.

This is NOT relevant to the use of the bridge in a tape library or MO

jukebox.

This option eliminates target IDs previously added.

SCSI Configuration Menu

Version X.X XXXX

Bus 1, Current SCSI Configuration:

Initiator SCSI ID: 7

Target SCSI ID(s):

Reset SCSI Bus on Boot: Yes

SCSI Initial Discovery Delay: 2000 ms

Initiator Mode Buffered Tape Writes: Enabled

Target Mode Buffered Tape Writes: Disabled

SCSI Termination: Internal

1) Change Initiator SCSI ID

2) Add Target SCSI ID

3) Remove Target SCSI ID

4) Toggle SCSI Reset Operation

5) Change Discovery Delay Time

6) Toggle Initiator Mode Buffered Tape Writes

7) Toggle Target Mode Buffered Tape Writes

8) Toggle SCSI Termination Mode (FC 2/1 only)

X) Return to previous menu