1 HV Installation and Operations Guide

Chapter 4 Perform Configuration 95

Chapter 4

Fibre Channel-to-SCSI Mapping

This option allows selecting the addressing mode of the bridge, as well as

displaying attached devices when using the bridge in initiator mode. The menu

to modify the indexed addressing table is also accessed through this menu.

The current mapping appears when option 5) is selected from the following

menu.

■ Select 1) to display attached SCSI devices according to ascending LUN

order.

■ Select 2) to display attached SCSI devices according to ascending SCSI

target ID (SCSI device address ID) order.

■ Select 3) to display attached SCSI devices in ascending SCSI bus

number (SCSI port ID number) order.

■ Select 4) to change the mode of Fibre Channel to SCSI mapping to one

of the following options:

1. Set to SCC

2. Set to Indexed

3. Set to Auto-assigned, LUN priority

4. Set to Auto-assigned, target ID priority

5. Set to Auto-assigned, bus number priority

SCC addressing is used to address SCSI devices attached to the bridge using

the SCSI-3 controller commands method of logical unit addressing. In this

mode, the bridge will respond to FCP commands as in a SCC controller device.

The FC HBA must support this addressing method.

Fibre Channel to SCSI Configuration Menu

Version X.X XXXX

Current Fibre Channel to SCSI Mapping Mode is Indexed

1) Display Attached SCSI Devices, LUN Priority

2) Display Attached SCSI Devices, Target ID Priority

3) Display Attached SCSI Devices, Bus Number Priority

4) Change the Fibre Channel to SCSI Mapping Mode

5) Show/Edit Fibre Channel to SCSI Mapping Table

X) Return to previous menu