SAN Solution Installation Guide

Installation
Tape Libraries
Chapter 22-14
NOTE Make sure version 1.14 or later is installed before proceeding. Refer to
Appendix A, Firmware Version Table.
Figure 2-5 Example of Connections as Shown on the 6/140
1 Host 6 SCSI cable from bus 1 on the Fibre
Channel card to drive 1
2 Switch 7 SCSI cable from the library
controller card to drive 1
3 Remote management card
LAN connection
8 SCSI cable from bus 2 on the Fibre
Channel card to drive 2
4 Fibre Channel cable 9 Appropriate SCSI terminator
5 Appropriate SCSI terminator