SAN Solution Installation Guide

Installation
Tape Libraries
Chapter 22-16
4. Use the
[+] or [-] keys to select the time zone. UTC stands for
Coordinated Universal Time.
5. Select
[OK] when complete to save the changes. A message confirms
your changes. You can also select
[Quit] to exit and not save the
changes.
Setting the Library’s IP Address via the Remote Management
Card (RMC):
NOTE Contact your network administrator to obtain the IP address, subnet
mask, and gateway address.
1. Install a RJ-45 connector into the network port of the RMC.
2. On the library’s back panel, verify that the link LED on the RMC is
green.
3. From the front panel, enter the IP address, subnet mask, and
gateway address:
[Main Menu > Administration > Change Configuration >
Network Access].
a. Enter the
[Network Access] menu.
b. Enter the
[IP Address].
Use the
[+] key to change the number
Use the
[->] key to move to the next number.
Use the
[Down] key to move to the next address.
c. Enter the
[Subnet Mask] using the same procedure.
d. Verify the gateway address. The IP and subnet mask narrows the
valid options for the gateway address.
4. Select
[OK] when complete to save the changes, or press [Quit] to exit
the menu and not save the changes.
A message will display to confirm the changes you have entered or
alert you if the changes have not been saved.