SAN Solution Installation Guide

Installation
Tape Libraries
Chapter 22-20
To power-on the 10/180 library, lift the switch or switches behind the
rear door (see Figure 2-7).
Figure 2-7 Powering-on the 10/180 Library
NOTE Verify the correct firmware is installed by referring to Appendix A,
Firmware Version Table.
Initializing the Library
Powering-on the library causes it to perform an initialization or IPL.
During IPL, the library initializes the robotic components, audits any
cartridges in the storage and reserved cells, and automatically verifies
some configuration values, such as drive locations and drive types.