SAN Solution Installation Guide

Installation
Tape Libraries
Chapter 2 2-27
9. When your choice is highlighted, press the
[SELECT] button to save
the changes. To abort, press the
[MENU] button. The Drive
Configuration screen will reappear.
10.Continue with these steps until all drives are configured.
11.If you have already changed the library’s SCSI ID and are planning to
exit the
Main Configuration menu at this time, you must press the
[RESET] button. If you wish to set other configuration values, continue
with the next section, “Placing the Library Online.”
Placing the Library Online
Before you place the library into operation, you must first:
1. Enter the system command to place all drives online.
2. When all drives are online, enter the command to place the library
online.
3. Enter the command to upload the library audit data to the client
system memory.
Sending Library Audit Data to Client
During an IPL, the library audits the location and VOLSER of all
cartridges in the storage and reserve cells. The library also performs an
audit when you:
• Power-on the tape library.
• Open and close the front library door.
• Reset the tape library.
• Make a request at the customer server console to audit the tape
library.
After the library is configured, you must follow every audit with a client
command that loads the library audit data into client memory. For
instructions on how to send this command, refer to your software and
system publications.