SAN Solution Installation Guide

Index
Index 1
A
abbreviations, 1-2
arbitrated loop, 1-4
asynchronous, glossary-1
B
backup software, 2-40
Bridges, Fibre Channel
Bridge 4/1 HV, 2-29
connect to a SAN, 2-30
connect to SCSI bus, 2-30
GBIC protector, 2-30
SCSI Bridge 4/2, 2-28
connect to a SAN, 2-28
C
cabling, 1-5
components, 1-1
D
differential SCSI, glossary-1
F
FC-AL, 1, 2
FC-SW, glossary-1
Fibre Bridge, glossary-1
Fibre Channel, glossary-1
G
GBIC, 1-5
Gigabit, glossary-1
Gigabit Interface Converter
GBIC), glossary-1
GLM, 1-5, glossary-2
H
host bus adapter, 2-32
hardware, 2-33
software driver, Windows NT,
2-32
HP-UX FC software drivers, 2-37
installing v10.2, 2-38
installing v11.0, 2-37
Hubs, 2-8
invalid/unsupported
configuration, 2-10, 2-11,
2-12
multi-port, 1-6
valid/supported configuration,
2-9
I
installation, 2-1
order of, 2-3
M
MIA, glossary-2
Multicast, glossary-2
N
narrow SCSI, glossary-2
Non-OFC, glossary-2
N-Port support, 2-35
disable, 2-36
enable, 2-35
O
OFC, glossary-2
originator, glossary-2
P
plug-in modules, 1-5
point-to-point, 1-4
port, glossary-2
protocol, glossary-3
R
receiver, glossary-3
S
single-ended SCSI, glossary-3
supported storage devices, 1-7
switched fabric, 1-4
switches 1-6, 2-4
configurations not supported,
2-7
firmware versions, 2-7
installing into a SAN, 2-4
IP address, 2-5
managing using Telnet, 2-6
serial connection pinout, 2-6
SilkWorm 2400, 2-5
SilkWorm 2800, 2-4
T
tape libraries, 2-13
Models 10/180 and 20/700,
2-17
audit data to client, 2-27