958-000289-001, June 2003)

Installing and Configuring the Director 2/64

101Director 2/64 Installation Guide

Configure and Enable E-mail Notification

Use this procedure to configure and enable e-mail addresses and Simple Mail

Transfer Protocol (SMTP) server addresses to receive e-mail notification of

director (and other managed product) events. The addresses must be configured

via HAFM, then enabled. See “Test Remote Notification” on page 109.

Use these steps to configure and enable e-mail and SMTP server addresses:

1. Open the Products View page, choose Maintenance > Configure E-Mail.

The Configure E-Mail dialog box displays, as shown in Figure 45.

Figure 45: Configure E-Mail dialog box

a. Type the IP address or DNS host name of the SMTP server in the SMTP

Server field. Use 64 or fewer alphanumeric characters.

b. For the E-Mail Addresses fields, type the e-mail addresses of up to five

recipients who should be informed of system events. Use 64 or fewer

alphanumeric characters for each entry.

2. To enable e-mail transmission of configured addresses, click Enable E-Mail

Event Notification. A check mark displays in the box when transmission is

enabled.

Note: Using HAFM, enable or disable e-mail event notification for each director

individually.

3. Click OK to save the information and close the dialog box.

4. Double-click the Director 2/64 icon. The Hardware View page for the

selected director displays.