958-000289-001, June 2003)

Installing and Configuring the Director 2/64

49Director 2/64 Installation Guide

Install the Director in a Rack

The following sections provide instructions for installing the Director 2/64 in

either the 9000/10000/11000 rack or in the HP system/e and industry-standard

19-in racks. If you plan to install the director in the optional M-Series Rack, refer

to the HP StorageWorks M-Series Rack Mount Kit Installation Instructions.

Required Tools

Obtain the following tools:

■ For a HP system/e and industry-standard 19-in rack:

— #2 Phillips screwdriver

— Torque screwdriver

■ For a 9000/10000/11000 rack:

— #2 Phillips screwdriver

— Torx head driver T25

Tips for Installing More than One Switch

Review the following tips:

■ Install the first director in the lowest position of the rack, allocated for

switches.

■ If installing more than one switch, Hewlett-Packard recommends installing an

optional PDU in the bottom of the rack. Hewlett-Packard ships two PDU

power cords with the Director 2/64.

■ Install additional switches in position directly above one another.

■ Make sure to connect power cables as you install each individual switch.

Transfer the Director to the Lift Device

Use these steps to position the Director 2/64 next to the rack.