Manualshelf

fw 05.01.00 and sw 07.01.00 - Universal Port Module Kit - Installation Instructions

ManualsBrandsHP ManualsStorageHP Surestore Director fc-64
11121314151617181920
Installation Instructions
15Universal Port Module Kit Installation Instructions
Installing the UPM
This section describes procedures to install one UPM card, even though you can
install more than one UPM card at the same time. If you are installing more than
one UPM card, ensure that the procedure steps are applied to all UPM cards being
installed. In addition, this section provides procedural notes and ESD information.
Procedural Notes
The following procedural notes are referenced as applicable. The notes do not
necessarily apply to all procedures in the chapter.
■ When performing procedures described in this chapter, follow all electrostatic
discharge (ESD) procedures, WARNING and CAUTION statements, and
statements listed in the preface of this manual.
■ After completing the steps of a detailed procedure that is referenced from
another procedure, return to the initial (referencing) procedure and continue to
the next step of that procedure.
ESD Information
When performing procedures described in this section, follow all ESD
procedures, WARNING statements, and CAUTION statements. When installing
UPMs, always connect a grounding cable to the director chassis and wear an ESD
wrist strap.
Caution: To avoid causing machine errors or damage while working on the
director, follow ESD procedures by connecting a grounding cable to the
director chassis and wearing an ESD wrist strap.
The ESD grounding point for the front of the Director 2/64 chassis is located at
the bottom center, adjacent to the left power supply, as shown in Figure 1. The
ESD grounding points for the front of the Director 2/140 chassis are located at the
right and left sides of the chassis, as shown in Figure 2.
Touch the chassis once before performing any maintenance action, and once each
minute while installing UPMs. If the director is not connected to facility power
(and therefore not grounded), connect the ESD wrist strap to an approved bench
grounding point instead of the chassis.