fw 05.01.00 and sw 07.01.00 - Universal Port Module Kit - Installation Instructions

Installation Instructions
26 Universal Port Module Kit Installation Instructions
Figure 8: Port Diagnostics dialog box
9. Select a port or UPM card for test, perform one of the following:
— To select an individual port for test, type the port number in the Port
Number field.
— To select a UPM card for test, type the port number of any of the four
ports an the card in the Port Number field, then choose All Ports On
Card.
10. At the Diagnostics Test list box, choose External Loopback.
11. Click Next. Beaconing initiates for the port or UPM card selected for test.
At the Hardware View, a yellow triangle displays at the top of the UPM card.
At the Port Diagnostics dialog box, the following message displays:
Loopback plug(s) must be installed on ports being diagnosed.
12. Verify loopback plug(s) are installed and click Next. The following message
displays:
Verify selected ports are beaconing.
13. Verify beaconing is enabled, then click Next. The following message
displays:
Press START TEST to begin diagnostics.
The Next button changes to Start Test.
14. Click Start Test. The test begins and:
—The Start Test button changes to Stop Test.