HP Surestore Director FC-64 Command Line Interface User's Guide

config 21
CLI Commands
config
The c onfig branch o f the CLI co mmand tree co ntains c ommands that set parameter values.
These values are not temporary ( session) values, but are retained acro ss power cycles.
The commands in the config branch can by used only by the Administrator.
Note that the co nfig.zo ning co mmands function in a different way fro m the o ther CLI
co mmands, which are single actio n c o mmands that take effect immediately. A zoning
configuration is typically to o complicated to be described by a single command, so the first
zoning command entered invokes a work area editor. The commands take effect on a
temporary co py of a zone set in the work area until the tempo rary co py in the wo rk area is
activated to the fabric--or is discarded.
Because not all the verification of the zone set can occur on the temporary copy in the
work area, it is possible, however unlikely, that the copy of the zone set encounters no
errors until the zone set is activated to the fabric.
config.ip.ethernet
Syntax
ethernet ipAddress gatewayAddress subnetMask
Purpose
This command sets the Ethernet network settings.
Description
Note The Telnet co nnec tion c an be lost when these Ethernet network settings are
changed.