Installation Guide

3 of 8 H
Step 3: Position and attach the rear
brackets
Locate the lowest U of the 15 you chose for mounting
the switch (the lowest being U1). Attach the rear rail-
tray brackets to the rear rack uprights at U1. Use one
M5 Torx screw for each bracket.
Step 4: Install the Tinnerman nuts on the
front uprights
Install the Tinnerman nuts for the top holes of U1 in
both of the rack’s front uprights.
M5 Screw
with attached
lock washer
HP rack
Rear Tray
bracket
Tinnerman
nut
Outer surface of
HP rack