Installation Guide

5 of 8 H
Step 8: Prepare the back rack columns
Standing at the back of the rack, count up from the
the top of the rail tray (A) to 12th and 28th on the
rack’s back face.
Slide a sheet metal nut (B) on each of the located
holes. You should have two sheet metal nuts on each
back column face (C).
Step 9: Install the rack mount kit on the
switch
Position the front mounting bracket (A) so that its
angled side faces out and it is on upper part of
switch's side. Using the two center threaded holes on
the front side of the switch, attach the bracket with
flat-head Phillips screws (B). Attach the front
mounting brackets on both sides of the switch.
Position the rear mounting bracket (C) so that its
center holes (D) line up with the first and third
threaded holes on the back portion of the switch's
side. The slotted end (E) of the bracket should face
towards the back of the switch. Using two flat-head
Phillips screws, attach the rear mounting bracket to
the switch. Attach both rear mounting brackets.