HP Surestore DLT Removable Tape Drive User's Guide

Operating the Drive
Using the Cartridge Locking Handle
2-6
To unload a tape cartridge:
2 The yellow “Tape in Use” light flashes while the tape
is rewound.
This could take up to 2 minutes, depending where on
the tape the drive was last reading or writing.
5 Remove the cartridge and replace it in its plastic case.
Replace the cartridge in its case immediately to
protect it from dust.
6 Push the Cartridge Locking Handle so that it swings
down.
Caution Make a habit of pushing the handle down after you
remove a cartridge. If the tape drive is powered down
with the handle up, the drive will not accept a
cartridge until you have pushed the handle down and
up twice.
1 Press the Unload button.
3 Wait for the green “Operate Handle” light to be lit.
4 Pull the Cartridge Locking Handle so that it swings
up.
dlt-m.book Page 6 Thursday, May 4, 2000 3:52 PM