Setting Up Your HP SureStore E Tape Library

hp surestore
tape library
2/20, 4/40, 6/60
setting up your library
SCSI Interface Cable(s): Four-meter SCSI cable(s)
with 68-pin connectors.
SCSI Terminator(s): 68-pin SCSI terminator (HVDS
or LVDS) to terminate the SCSI chain.
Fibre Channel Cable: Optical short-wave cable that
connects the Fibre Channel card to the host, hub,
or switch (for Fibre Channel configurations).
Fibre Channel GBIC: Connects the Fibre Channel
cable to the host, hub, or switch (for standard
performance Fibre Channel controllers only).
SCSI Jumper Cable(s): 68-pin cable that connects
the library controller or Fibre Channel card to a
drive.
Tape Cartridges: Cartridges included for data
backup.
Cleaning Cartridge: Cleaning cartridge to be used
when cleaning the drive.
Power Cord(s): Localized power cord(s) included
with the library.
User's Guide: Describes installation, operation, and
troubleshooting information.
Installation Poster: Provides an overview on
installing and configuring the library, as well as
additional information on support.
Trim Brackets (field rack only): Aligns the library to
the depth of the rack.
Host Interface Card: Install into the host system as
needed for your configuration.
Bar Code Label Kit: Bar code labels for data and
cleaning cartridges, and reordering information.
®
Library Accessories
Depending on the configuration, the following accessories may be shipped with the library.
Contact your support or service representative to obtain additional parts.

Summary of content (7 pages)