Fabric OS Reference Manual

Telnet Commands 105
ipAddrSet
Set Ethernet and FC IP addresses.
Synopsis
ipAddrSet
Availability admin
Description Use this command to set Ethernet and FC IP addresses. You are prompted
for address end mask information:
• Ethernet IP Address: IP address of the Ethernet port
• Ethernet Subnetmask: IP subnet mask of the ethernet port
• Fibre Channel IP Address: IP address of the fibre channel ports
• Fibre Channel Subnetmask: IP subnet mask of the fibre channel ports
• Gateway Address: IP address of the gateway
After each prompt, the current value is shown. You can respond in several
ways:
• Press
return
to retain the current value.
• Enter an IP address in conventional dot (‘.’) notation.
• Enter
none
.
• Press
control-C
to cancel changes.
• Press
control-D
to accept changes and end input.
The final prompt allows you to set the new IP addresses immediately. Enter
y
to set new addresses immediately; enter
n
to delay the changes until the
next switch reboot. (Entering
y
closes the telnet session.)
A change to these values issues a Domain Address format RSCN (see
FC-FLA for a description of RSCNs).
Operands None.