HP Surestore FC Swtich 6164 Quick Start Guide

22 Quick Start Guide
b. Use four #8-32 x 5/16-inch Phillips flat-head screws to mount one of
the stationary plates onto each side of the switch. The plates must be
oriented so that the end of the plate that has the slotted holes protrudes
past the back of the switch, and if the plate has arrows stamped into
it, the arrows must point up (see Figure 10). Do not tighten the screws
fully at this time.
Note
Some stationary plates have arrows stamped into them, and some
do not. The arrow determines which side of the switch the plate must be
mounted on. If the stationary plates provided with the switch do not
have arrows, they can be mounted on either side.
Figure 10. Mounting the Rack-Mount Bracket Stationary Plates to the Switch