HP Surestore FC Swtich 6164 Quick Start Guide

Installing the Switch 23
7. If you have adequate access to the back of the rack to insert the switch
from the back, skip Steps 8, 9, and 10. If you do not have adequate access
to the back of the rack, proceed with Step 8.
Note
If you cannot insert the switch into the rack from the back, you must
remove several pieces of hardware from the sides of the switch at the front
end as described in Steps 8, 9, and 10. If you have adequate access to insert
the switch into the rack from the back, you can skip these steps.
8. Remove the four #6-32 x 1/4-inch flat-head screws that attach each of the
two hinge plates to the left side of the switch at the front end (see
Figure 11). Set the screws and the hinge plates aside for later use.
Figure 11. Removing the Hinge Plates from the Switch
x 8