HP Surestore FC Swtich 6164 Quick Start Guide

26 Quick Start Guide
12.If you inserted the switch into the rack from the back, skip this step.
Reinstall the removed hardware:
a. Use the 16 #10-32 Phillips screws you removed in Step 10 to re-attach
the rack-mounting flanges to the switch (see Figure 12).
b. Use the two screws you removed in Step 9 to re-attach the latch plate
(see Figure 12). Make sure that there is a gap of approximately
3/16-inch between the edges of the latch plate and the edges of the
cutout in the rack-mounting flange.
c. Orient the hinge plates so that the sides that have the loops face each
other (see Figure 13). Use the eight #6-32 x 1/4-inch flat-head screws
you removed in Step 8 to re-attach the hinge plates to the left side of
the switch at the front end (see Figure 11).
13.Re-attach the rack-mount bracket adjustable plates:
a. From the front of the rack, slide the switch forward a short distance.
b. Insert one of the adjustable plates into one of the stationary plates (see
Figure 14).
Figure 13. Orienting the Hinge Plates Prior to Reinstallation
Loops